Can I secure a recently fired weapon with a hot barrel?
Yes. The Silicone Clip Covers can withstand temperatures as high as 500°
How do I clean a clip cover if necessary?
Mild soap and water should remove most substances from the cover. If you cannot clean the cover, we suggest you replace it.
Tip: To prevent damage to your weapon, replace worn or damage Clip Covers.
Tip: Installation - Clip Covers can be easily and quickly replaced. After removing the worn Cover, put a few drops of water on the inside of the new Clip Cover. This will allow the Cover to easily slide onto the clip arm. The water will evaporate, and the cover will be securely attached. When replacing a Clip Cover, stretch to open end of the Cover over the top of the Clip Arm and carefully slide the cover down the Arm. The closed end of the Cover is slightly thicker to give additional material support to the top edge and corners of the clip. Strategically placed vent holes allow air to escape when sliding the covers onto the clip. When properly installed, the closed end of the cover should be resting on the top of the clip arm. The bottom (open end) of the clip cover should be at the bottom of the Clip Arm.